​​Acceptance Test
​​Create a wiki page for acceptance test
​​
​​Check items on Hardware
  • ​​Cable connection (resistance, connected/disconnected)
  • ​​Put measured resistance values into the check sheet
  • ​​Calibration, Polarity (LVDT, ACC, ACT)
  • ​​Measure noise
  • ​​Paper note → klog → wiki
  • ​​Working point and dynamic range with FR, limit SW
  • ​​Minimum range = ??
  • ​​Optimal point needs to be pre-recorded
  • ​​Tuned frequencies of GAS Filters & IP
  • ​​Maximum frequencies = ??
​​  
​​Check items on Software (Control)
  • ​​Healthy check template
  • ​​TF measurements
  • ​​PreQUA ?
  • ​​Damping time RMS in spectrum
  • ​​Noise budget
  • ​​Guardian
​​